There are different flavors of STP, but 802.1D is the most popular and widely implemented. STP runs on bridges and switches that are 802.1D-compliant.

STP and MST (Catalyst 6500/6000 Switches that run Cisco IOS ®Software)Ĭonfigure STP and MST (Catalyst 4500/4000 Switches that run Cisco IOS Software) Refer to these documents for information on the configuration of STP on other switch platforms: The main purpose of STP is to ensure that you do not create loops when you have redundant paths in your network. The specification for STP is IEEE 802.1D. Spanning Tree Protocol (STP) is a Layer 2 protocol that runs on bridges and switches. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The spanning tree principles that the document presents are applicable to almost all devices that support STP. The information in this document is based on these software and hardware versions:Ī console cable that is suitable for the Supervisor Engine in the switch There are no specific requirements for this document. This document describes how to use Spanning Tree Protocol (STP) to ensure that you do not create loops when you have redundant paths in your network.

The first tree switch download free